KTM 250 EXC-F EU 2010, Owner'S Manual

Page: 99 / 136

15 ELECTRICAL SYSTEM
97
K00120-10
–
Pull out headlight bulb

.
–
Insert the new headlight bulb.
Headlight (HS1 / socket PX43t) ( p. 120)
–
Insert the protection cap with the bulb socket into the reflector and turn it clock-
wise all the way.
Info
Ensure that O-ring  is seated properly.
–
Insert the bulb socket of the parking light into the reflector.
Finishing work
–
Refit the headlight mask with the headlight. ( p. 96)
–
Check the headlight setting. ( p. 97)
15.9 Checking the headlight setting
400726-10
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance  under the first mark.
Guideline
Distance

5 cm (2 in)
–
Position the vehicle vertically a distance

away from the wall.
Guideline
Distance

5 m (16 ft)
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the light-dark border does not meet specifications:
–
Adjust the headlight range. ( p. 97)
15.10 Adjusting the headlight range
Preparatory work
–
Check the headlight setting. ( p. 97)
K00121-10
Main work
–
Loosen screw

.
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver (instructions on how to apply the mark: Checking the
headlight setting).
Info
A change in weight on the vehicle may require a correction of the headlight
range.
–
Tighten screw  .