KTM 250 EXC-F EU 2010, Owner'S Manual

Page: 56 / 136

12 SERVICE WORK ON THE CHASSIS
54
M01017-10
–
Remove O-ring

. Remove protective ring

.
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
12.10 Removing the lower triple clamp (XCF
‑
W)
Preparatory work
–
Remove the headlight mask with the headlight. ( p. 95)
–
Raise the motorcycle with the lift stand. ( p. 49)
–
Remove the front wheel. ( p. 87)
–
Remove the fork legs. ( p. 50)
–
Remove the front fender. ( p. 61)
–
Remove the handlebar cushion.
M00989-10
Main work
–
Open the cable holder in front of the right radiator and detach the wiring harness.
–
Remove screws

and hang the voltage regulator to one side.
–
Release screw

and remove screw

. Take off the upper triple clamp with the
handlebar and set it aside.
Info
Protect the components against damage by covering them.
Do not bend the cables and lines.
M00990-10
–
Remove O-ring  . Remove protective ring  .
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
12.11 Installing the lower triple clamp (All EXC
‑
F models)
B01604-10
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease ( p. 126)
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the upper steering head seal

is correctly positioned.
–
Slide on protective ring

and O-ring

.