KTM 2014 350 EXC-F SIX DAYS, Owner'S Manual

Page: 111 / 136

18 SERVICE WORK ON THE ENGINE
109
The engine oil is at a level between the lower edge
A
and the upper edge
C
of the level viewer.
» If the engine oil is not up to the lower edge
A
of the level viewer:
–
Add engine oil. ( p. 111)
18.3 Changing the engine oil and oil filter, cleaning the oil screen
x
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the engine oil only when the engine is warm.
Preparatory work
(EXC
‑
F AUS, All SIXDAYS models)
–
Remove the engine guard. ( p. 80)
–
Park the motorcycle on a level surface.
B01575-10
Main work
–
Place a suitable container under the engine.
–
Remove oil drain plug
1
with the magnet and seal ring.
Info
Do not remove screws
A
on both sides.
B01576-10
–
Remove screw plug
2
with oil screen
3
and the O-rings.
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
B01577-10
–
Push the oil screen with O-rings onto a pin wrench.
–
Push the pin wrench through the opening into the drill hole of the opposite engine
case wall and push the oil screen as far as possible into the engine case.