KTM 2013 1190 RC8 R JP, Owner'S Manual

Page: 161 / 272

11 SERVICE WORK ON THE CHASSIS
159
11.7 Fitting the seat
B01323-10
–
Position the recesses of the seat to the lugs on the frame, lower the rear end and simul-
taneously push it forward.
–
Lock the seat by turning the ignition key in the seat lock.
–
Remove the ignition key from the seat lock.
–
Finally, check that the seat is correctly mounted.
11.8 Mounting the helmet lock on the vehicle
Warning
Danger of accidents Impairment of ride behavior and vehicle operation if a helmet or helmet lock is attached to the vehicle.
–
Do not use the helmet lock for holding a helmet or other objects during the journey. Always remove the helmet lock before start-
ing out.
B01324-10
–
Remove the seat. ( p. 158)
–
Position the steel cable from the tool kit with one loop on the lug
1
.
Steel cable (60012015000)
–
Guide the steel cable through the helmet opening.
–
Then position the free loop of the steel cable on the lug.
–
Position the helmet carefully on the side of the vehicle.
–
Fit the seat. ( p. 159)