30/ENGINE ASSEMBLY
150
301687-10
–
Lock the outer clutch hub and primary gear with the special tool and tighten
nut
.
Guideline
Nut, primary gear
M27x1
80 Nm
(59 lbf ft)
Loctite
®
243™
Gear quadrant (80029004000) (
Info
Ensure that the crankshaft is not locked.
301685-11
–
Mount the inner clutch hub.
–
Position the new lock washer and mount nut
. Hold the inner clutch hub using
special tool
and tighten the nut.
Guideline
Nut, inner clutch hub
M18x1.5
80 Nm
(59 lbf ft)
Loctite
®
243™
Clutch holder (77329003000) (
–
Secure the nut with the lock washer.
301684-11
–
Thoroughly oil the clutch facing discs.
Engine oil (SAE 10W/50) (
–
Beginning with an intermediate disc, alternately insert all other clutch facing discs
and intermediate discs into the outer clutch hub.
–
Insert pressure piece
with the push rod into the gearbox main shaft.
301683-11
–
Position the crankshaft at TDC and lock it with the special tool.
Engine blocking screw (77329010000) (
–
Position pressure cap
. Mount screws
with the washers and springs. Tighten
the screws in a crisscross pattern.
Guideline
Screw, clutch spring
M6
10 Nm (7.4 lbf ft)
20.15
Installing the spacer
301652-10
–
Grease the shaft seal ring before mounting.
–
Position the O-ring. Mount spacer
with the bevel facing inward.
PartShark.com
877-999-5686