KTM 2010 1190 RC8, Owner'S Manual

Page: 226 / 258

CLEANING
224
13.1
Cleaning motorcycle
Note
Material damage Damage and destruction of components by high-pressure cleaning equipment.
–
Never clean the vehicle with high-pressure cleaning equipment or a strong water-jet. The excessive pressure can penetrate electrical
components, socket connects, throttle cables, and bearings, etc., and can damage or destroy these parts.
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
–
Before cleaning, seal the exhaust system to prevent water from entering.
–
Remove loose dirt first with a soft jet of water.
–
Spray very dirty parts with a normal commercial engine cleaner and then brush off with a soft brush.
Motorcycle cleaner ( p. 248)
Info
Use warm water mixed with a normal commercial engine cleaner and a soft sponge.
If the vehicle has been used on salted roads, clean it with cold water. Warm water intensifies the effects of salt.
–
After cleaning the motorcycle thoroughly with a soft jet of water, dry it with compressed air and a cloth.