KTM 200 EXC 2016, Setup Instructions

Page: 8 / 25

2 SETUP
6
V00040-01
(All EXC models)
–
Position the controls on the left half of the handlebar.
Info
The figure shows how to route the clutch line and wiring harness.
V00041-01
(XC-W, 300 XC
‑
W Six Days US)
–
Position the controls on the left half of the handlebar.
Info
The figure shows how to route the clutch line and wiring harness.
B01750-01
(All EXC models)
–
Remove the fuel tank. ( p. 10)
–
Disconnect the plug-in connector on the main wiring harness.
–
Connect the plug-in connector of the turn signal wiring harness with the plug-in
connector of the main wiring harness.
–
Position the turn signal wiring harness against the main wiring harness and
secure with cable ties.
–
Install the fuel tank. ( p. 11)
–
Position the turn signal indicator lamp in the speedometer holder.
B02188-10
–
Insert the black and violet cables of bulb included in the separate enclosure
into the socket and position it in the turn signal indicator lamp.
–
Secure turn signal relay  with a cable tie and plug in the connector.
–
Position the turn signal on each side and mount and tighten nuts  .
–
Connect the plug-in connector

of the right turn signal with the connector
marked green on the wiring harness.
–
Connect plug-in connector  of the left turn signal with the connector marked
red on the wiring harness.
402148-01
(All EXC models)
–
Mount the turn signal switch and connect the plug-in connector on the wiring
harness.