KTM 200 DUKE 2021, Owner'S Manual

Page: 77 / 119

ELECTRICAL SYSTEM 15
75
M00729-10
Main work
–
Connect a battery charger to the 12-V battery. Switch on the
battery charger.
Battery charger (58429074000)
In addition, this battery charger can be used to test the open-
circuit voltage, the starting ability of the 12-V battery, and
the alternator. It is impossible to overcharge the 12-V battery
using this device.
Info
Never remove cover
1
.
Charge the 12-V battery to a maximum of 10 % of the
capacity specified on battery housing
2
.
–
Switch off the battery charger after charging and disconnect
from the 12-V battery.
Guideline
The charging current, charging voltage, and charging time
must not be exceeded.
Recharge the 12-V battery
regularly when the motorcy-
cle is not being used
3 months
–
Position the negative cable and mount and tighten the screw.
–
Position the negative terminal cover.
Finishing work
–
Mount the front rider's seat. ( p. 52)
–
Mount the passenger seat. ( p. 52)
–
Set the clock. ( p. 32)
15.4 Changing the ABS fuses
Warning
Fire hazard
Incorrect fuses overload the electrical system.
–
Only use fuses with the required ampere value.
–
Do not bypass or repair fuses.
Info
Two fuses for the ABS are located under the passenger seat. These fuses protect the return pump and the
hydraulic unit of the ABS. The third fuse, which protects the ABS control unit, is located in the fuse box.
Preparatory work
–
Remove the passenger seat. ( p. 51)