2.10 Making Fiber Connection
The dual-speed SFP slots, Port 9 and Port 10 must be installed with an SFP fiber transceiver for making fiber
connection. Your switch may come with one or two SFP transceivers pre-installed when it is shipped.
Types of the SFP Fiber transceivers supported:
1000Mbps based 1000BASE-X SFP transceivers
100Mbps based 100BASE-FX SFP transceivers
Installing SFP Fiber Transceiver
To install an SFP fiber transceiver into SFP slot, the steps are:
1.
Turn off the power to the switch.
2.
Insert the SFP fiber transceiver into the SFP slot. Normally, a bail is provided for every SFP
transceiver. Hold the bail and make insertion.
3.
Until the SFP transceiver is seated securely in the slot, place the bail in lock position.
Connecting Fiber Cables
LC connectors are commonly equipped on most SFP transceivers. Identify TX and RX connector
before making cable connection. The following figure illustrates a connection example between two
fiber ports:
Make sure the Rx-to-Tx connection rule is followed on the both ends of the fiber cable.
-21-
Summary of Contents for KGS-1060
Page 13: ...Dimensions 13 ...
Page 15: ...Dimensions 15 ...
