CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written
authorization. K.T.C. S.r.l. shall safeguard its rights to the full extent of the law.
OPERATION AND INSTALLATION MANUAL
COD. 091114 – COMPACK 2 ECO / SPECIAL - REV. 08 - DATE 10/2020
page
33
of
63
8
OPERATION AND USE
8.1
DESCRIPTION OF THE OPERATION
For the machine functions, see chap. 4.
8.2
RANGE OF APPLICATIONS
The machine is suited to all those applications requiring compressed air at the flow rate and
pressure outlined in the technical data sheet (see chap. 5).
8.3
PROPER AND IMPROPER USE
CAUTION!
The compressor is designed and built solely to produce compressed air.
The manufacturer is relieved of any responsibility for risks ensuing from any other
use.
CAUTION!
Any use of the compressor that differs from the agreements made at the time of
purchase relieves the manufacturer of any responsibility for ensuing injury or
property damage or damage to the machine itself.
CAUTION!
The electrical system cannot be used in flame-proof areas and with flammable
products.
CAUTION!
Never direct air jet toward persons or animals.
Never use compressed air for breathing or in production processes where the air
produced is in direct contact with foodstuffs, unless previously treated and filtered.
8.4
OPERATING AND ENVIRONMENTAL LIMITS
The operating and environmental limits are indicated in the table containing the technical data and
characteristics (see chap.5).
8.5
WORKSTATION AND DANGEROUS AREAS
During normal operation of the machine, the operator works on the side where the electronic
controller / ignition switch is located. Once correctly connected to the electrical and pneumatic
system, the machine is completely protected on the outside and thus there are no dangerous areas
accessible during normal operation.
When scheduled and unscheduled maintenance is performed, the machine is completely open.
These operations must be performed under safe conditions by qualified personnel.
