15
⑤
REMAINING AMOUNT INDICATION
When the level of brake fluid in Tank becoms below1, the edge of Piston can
be seen at the window for remaining amount indication.
Gauge on Indicator(the window of remaining amount indication) is graduated
at 0.2.
NOTE
･
Indicator(the window for remaining amount indication shows the remaining
brake fluid to be pressure-sending. So it does not indicate the correct amount
before removing air in Tank.
0.8 0.6 0.4 0.2 (litre)
Indicator (the window for remaining amount indication)
⑥
FILLING BRAKE FLUID
・
A.Filling Whole capacity(Max. 2 litres )
Turn Switch Lever from Neutral(
中立
) to Discharge(
排気
), Open Cap and inject
brake fluid(Please refer to Page 6)
B.Filling less than the whole capacity.
※
Removing air from Tank is needed.
NOTE
･
Remove air from Tank, otherwise brake fluid get mixed with air.
･
Disconnect Attachment from Socket Coupler when removing air.
･
If attachment not disconnected, brake fluid may be poured out.
(1) .Connect the air coupler with Body, Turn Switch Lever from Neutral (
中立
) to
Discharge (
排 気
), open Cap and inject brake fluid. After the injection,
fasten Cap to Lock Position.
NOTE
･
Do operation in leveled floor.
･
Be careful not to allow trash, dust, etc. enter into Tank.
･
Do not give any damage on rubber packing, otherwise the pressure May be
down.
･
After long non-use period, turn Switch Lever from Pressure-Sending (
圧送
)
to Discharge (
排気
) as the piston may not return quickly.
(2) Loosen Cap within the range specified in Cap Label. Turn Switch Lever to
Pressure-Sending (
圧送
), then air gets out of Cap and Brake fluid start to blur
Summary of Contents for ABX70
Page 3: ...3 1 PART BODY ATTACHMENT...