8. OSD MANUAL
PRIVACY
PRIVACY:
Allows upto 8 masks to be applied to the image (note that if motion
area in motion det menu is set to ‘on’, this reduces to 4 privacy zones)
Area Sel:
1 - 8
(Selects the motion detection area)
Top:
0 – 288 (increments of 1) 0=top, 288=bottom
Bottom:
0 – 288 (increments of 1) 0=top, 288=bottom
Left:
0 – 468 (increments of 1) 0=left, 468=right
Right:
0 – 468 (increments of 1) 0=left, 468=right
Colour:
1 – 8
(Choose from the following colours for the privacy zones - red, green, blue, lime,
cyan, magenta, white, black)
Transp:
0.00, 0.50, 0.75, 1.00
(Sets the transparency of the privacy zone area)
Mosaic:
Off, On
(When mosaic is set to On, all programmed privacy zones switch to a non-
adjustable mosaic/tile distortion effect. For full mosaic, Transp needs to be set to
0.00)
DAY / NIGHT
Day / Night:
make changes to the camera operation
Modes:
Auto, Colour, B/W, EXT1, EXT2
(please note that the camera switches between colour/monochrome images
via the Photocell with EXT1 setting. If you wish to change Burst or IR Optimizer
settings then you will need to put the camera into B/W mode).
Auto:
Switches via AGC – does not activate IR LEDs
Colour:
Colour only operation
B/W:
Monochrome only operation
Burst:
Off, On
(Allows the colour burst signal in monochrome to be removed if required)
IR Optimizer:
Off, On
Mode:
Auto, Centre
Level:
0 – 31 (increments of 1)
EXT1:
Photocell switching between colour/monochrome and activates IR LEDs
EXT2:
Not used
17
