When you install the camera, please glue up the end of cable to
keep it stable in order to protect the camera from the humidity problems.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasnoable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio communications.
However, there is no guarantree that interference will not occur in a particular installation. If this equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Note -
• Reorient or relocate the receiving antena.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
whice the receiver is connected.
•Consult the dealer or an experienced radio / tv technician for helf.
Any changes or modifications in construction of this devies which are not expressly approved
by the party responsible for compliance could void the user's authority to operate the
equipment.
Caution -
1. A regulated DC12V 500mA power supply is recommended for use with this camera
for the best picture and the most stable operation.
An unregulated power supply can cause damage to the camera.
When unregulated power supply is applied, product warranty will be
out of subject.
2. It is recommended that the camera is used with a monitor that has a CCTV quality
75 video impedance level.
If your monitor is switched to high impedance then please adjust accordingly.
3. Do not attempt to disassmble the camera to gain access to the internal conponets.
Refer servicing to your dealer.
4. Never face the camera towards the sun or any bright or reflective light, which may
cause smear on the picture and possible damage to the CCD.
5. Do not remove the serial sticker for the warranty service.
DIMENSIONS
CONNECTION
INSTALLATION / OVERVIEW
Unit : mm
◀
When using a wide angle lens
of 2.45mm, Tilt is not available
over 50°.
1
2
3
4
6
7
8
5
5
5
5
①
CASE HOUSING TOP
②
CASE HOUSING COVER
③
HOLDER ROTATION
④
LENS
⑤
SCREW
⑥
HOLDER TILTING
⑦
HOLDER PANNING
⑧
CASE HOUSING BOTTOM
3-AXIS Gimbal Bracket
