KSV SPOT Manual
5.1.3. Using KSV SPOT with third party devices
KSV SPOT has also an analog output for third party devices with analog input.
Analog output is from -5V to +5V.
Connection diagram is shown below.
5.1.4. Calibration of the KSV SPOT
NOTICE! The KSV SPOT is factory calibrated and there should be no need for re
it.
Below is described the calibration procedure in case calibration is needed.
Connect a DC-power supply between
front panel. The positive voltage should be connected to Counter Electrode and ground to
RCA connector. The voltage should be between 2.0
Start SpotMonitor or KSV Win
D
1
5
H
D
m
a
le
9
ing KSV SPOT with third party devices
also an analog output for third party devices with analog input.
5V to +5V. The KSV SPOT re12Vdc operating voltage.
is shown below.
. Calibration of the KSV SPOT
KSV SPOT is factory calibrated and there should be no need for re
Below is described the calibration procedure in case calibration is needed.
power supply between Counter Electrode and the RCA connector on SPOT
he positive voltage should be connected to Counter Electrode and ground to
RCA connector. The voltage should be between 2.0 – 3.5Vdc.
KSV WinLB software.
D
1
5
H
D
m
a
le
1
5
1
1
1
5
input +12Vdc
input GND
output
output GND
2
4
6
7
KSV SPOT
Rev. 1.0
also an analog output for third party devices with analog input.
SPOT re12Vdc operating voltage.
KSV SPOT is factory calibrated and there should be no need for re-calibrating
Below is described the calibration procedure in case calibration is needed.
the RCA connector on SPOT
he positive voltage should be connected to Counter Electrode and ground to
