1.
INTRODUCTION:
This Anchor is classed as Personnel Protective Equipment (PPE) by the European PPE Regulation (EU)2016/425 and has
been shown to comply with this Regulation through the Harmonized European Standard EN 795:2012 Type A.
2.
PERFORMANCE AND LIMITATIONS OF USE:
The Anchor has been tested in accordance with EN 795:2012 Type A and has achieved the
following performance levels:
Please read and understand the manufacturer's instructions for each component or part of the complete system. Manufacturer's instructions
must be followed for proper use, care, and maintenance of this product. These instructions must be retained and be kept available for the user's
reference at all times. Alterations or misuse of this product, or failure to follow instructions, may result in serious injury or death.
Note:
The user is advised to keep this user instructions document for the life of the product.
EN 795:2012 Type A test
Result/Comment
General Requirements
PASS)
for Anchor devices
(Clause 4.1)
No sharp edges (PASS).
Static Strength
Sustained a force of 12 kN for 3 minutes (PASS).
(Clause 4.4.2.3)
Dynamic Strength & Integrity Test
When tested with rigid steel mass of 100 kg, the test mass held after test with the device
(Clause 4.4.1.2)
remaining stable throughout. (PASS).
Anchor Holds an increased load of 300kg for 3 min following dynamic test.
Corrosion Resistence
No corrosion evident after 48 hours of salt spray testing. (PASS)
(Clause 4.2.2.1)
3.
APPLICATION:
Quick and Easy to install, this steel anchor is designed to be installed on metal I Beam.
4.
INSPECTION:
Visually inspect the system before each use to ensure that it is in a serviceable condition and is operating correctly. If during inspection,
doubts are raised about the safety of the system or a component, these should be replaced either by the manufacturer or a competent
person.
A formal inspection of fall protection products/components must be performed preferably every six months or at least annually by a
competent person other than the user. The frequency of formal inspections should be based on conditions of use or exposure. Record
the inspection results in the inspection and maintenance log at the end of this manual. The component should be checked for cut, frayed,
heavily soiled, welding burns etc. Metal parts like D-rings should be duly check for the crack, bent, deformities, corrosion etc.
5.
PRECAUTIONS:
Ÿ
Ensure the Medical condition of the user does not affect his safety in normal and emergency use.
Ÿ
The equipment shall only be used by a person trained and competent in its safe use.
Ÿ
A rescue plan shall be in place to deal with any emergencies that could arise during the work.
Ÿ
Ensure that the anchor is installed directly above the user's head.
Ÿ
Ensure that the equipment is compatible with other items when assembled into a system.
Ÿ
It is essential to verify free space required beneath the user at work place before each occasion of use so that in case of a fall there will be
no collision with ground or other obstacle in the fall path.
Ÿ
Ÿ
6.
PRE-USE CHECK:
Ÿ
It is important to check before use, any dangers that may arise by the use of combinations of items of the equipment in which the safe
function of any one item is affected by or interferes with the safe function of another.
Ÿ
Carry out a pre-use check of the system, to ensure that it is in a serviceable condition and operates correctly before it is used.
Ÿ
Ensure the compatibility of items of equipment when assembled into a system.
01
