1H 3H
6H 0N
LIGHT
MIST
1. Position the Aroma Diffuser upright, pull vertically
upwards to remove cover. (Fig. 1)
2. Connect AC adaptor power cord into the DC input jack
at the base of the Aroma Diffuser. It is suggested to
route cable via track provided. (Fig. 2)
3. Pour water and essential oil into Aroma Diffuser. DO
NOT fill in excess of 'MAX' marking 300ml. DO NOT
use boiling water. DO NOT fill when power is on. It is
recommended to add 2-3 drops of essential oil for
each 100ml of water. (Fig. 3)
4. Re-install cover. Spout is adjustable to guide aroma
into desired direction. Aroma Diffuser must NOT be
operated without the cover. (Fig. 4)
5. Connect AC adaptor with power from wall socket.
6. To switch on, press “MIST” and choose operation time
required (1 hour, 3 hour, 6 hour or ON Continuous).
Mist level is adjustable by hard-pressing “MIST” until
the Aroma Diffuser beeps (One beep for high and two
beeps for low). To switch off, press 'MIST' through
following cycle until it is off. (1 hour -> 3 hour -> 6 hour
-> ON Continuous -> Off) (Fig. 5)
7. Press “LIGHT” to switch on LED light. Brightness is
adjustable through the following cycle. (Bright ->
Dim -> Off) (Fig. 6)
8. It is recommended to drain water from tank and keep dry
for extended idle period.
9. When connect with power,the original state of aroma
diffuser is still off.
10. Misting operation and light will switch off automatically
when there is insufficient water, even press “MIST” ,
aroma diffuser is also switch off automatic.
OPERATION
Water Outlet
●
The amount and intensity of mist produced will vary, but this is not unusual and should not
be considered as a fault.
●
Factors that affect this include water type, humidity, temperature, air currents.
●
Auto power off when water runs out.
●
Applies only 100% natural essential oil, if they contain chemical ingredients, flavors or
impurities may cause damage to the product.
●
Before replacing another essential oil, follow the maintenance part to clean the product.
ATTENTION
ACCIDENTAL LEAKAGE
In the event of the unit being knocked over or tipped during use, please
follow the steps as below to avoid malfunction:
1. Unplug the unit and remove cover.
2. Pour out any remaining water from the water tank.
3. Shake the unit gently to drain water,and then keep it natural air drying for at least
24 hours.
