Ksenukai FXAM1H-ZP2-1-250E, Instruction Manual

Page: 15 / 136

15
g) If devices are provided for the connection of dust
extraction and collection facilities, ensure these
are connected and properly used. Use of these
devices can reduce dust related hazards.
4) POWER TOOL USE AND CARE
a) Do not force the power tool. Use the correct
power tool for your application. The correct power
tool will do the job better and safer at the rate for
which it was designed.
b) Do not use the power tool if the switch does not
turn it on and off. Any power tool that cannot be
controlled with the switch is dangerous and must
be repaired.
c) Disconnect the plug from the power source before
making any adjustments, changing accessories, or
storing power tools. Such preventive safety
measures reduce the risk of starting the power
tool accidentally.
d) Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the
power tool or these instructions to operate the
power tool. Power tools are dangerous in the
hands of untrained users.
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tools operation. If damaged, have the power tool
repaired before use. Many accidents are caused
by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.,
in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions
and the work to be performed. Use of the power
tool for operations different from intended could
result in a hazardous situation.
5) SERVICE
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
COMPONENTS & CONTROLS (FIG 1)
PARTS LIST (FIG 2)
A. Bevel adjustment hand wheel
B. Bevel locking knob
C. Blade guard
D. Dust extraction hose
E. Rip fence
F. Rip fence locking handle
G. Tool storage
H. Right hand side table extension locking knob
(1 front, 1 rear)
I. Wheel
J. Latching pin
K. On/Off Switch
L. Push stick storage
M. Left hand side table extension locking knob
(1 front, 1 rear)
N. Sliding carriage unlocking pin
O. Sliding mitre fence
P. Riving knife
Q. Blade
1. Flat end caps x 6
2. Round end caps x 2
3. M8 x 78mm bolt x 8
4. M8 nut x 8
5. Spacer x 8
6. M6 x 75mm bolt x 4
7. M6 silver washer x 4
8. M6 black washer x 4
9. M6 nut x 4
10. M5 x 50mm bolt x 2
11. M5 x 40mm bolt x 4
12. M5 nut x 6
13. Wheel bolt x 2
14. Wheel washer x 2
15. Wheel small washer x 2
16. Wheel nut x 2