KSB MEGAFLOW 100-250, Operating Instructions Manual

Page: 23 / 46

KSB Megaflow
23
15. Maintenance
15.1 Bearing Maintenance
a) Remove vent plug. Tilt the reservoir down. Pour oil through the hole left by the vent plug until oil appears in the vertical
section of the elbow connecting bearing bracket and reservoir.
b) Fill up the reservoir
c) Snap the reservoir back into position. After 10 minutes, check wether the oil level in the reservoir has dropped into the
support, completing this way the necessary level, which is the centerline of the inferior ball bearing indicated in the Fig.
18.
During the pump operation, if oil level reduce to approximately 1/3 of the reservoir capacity, it must be filled up according to
the instructions mentioned in this item.
Attention: A defective lubrication or an excessive one may cause damage.
Fig.18 – Constant-Level-Oiler
15.2 Lubrication intervals and oil specifications
The first oil change should be made after the first 200 or 300 working hours. The next oil change should be made after 1500
or 2000 service hours. This will avoid dirt particles, which have not been eliminated by cleaning, to contaminate oil and
damage bearings.
Then, oil change should be made every 8000 effective working hours or at least once a year (the one becomes first).
Bearings should be washed every 2 years (as a minimum).
Manufacturer Up to 3.000 rpm Over 3.000 rpm
ATLANTIC EUREKA – 68 EUREKA-68
CASTROL - -
ESSO Turbine Oil 68 Turbine Oil 46
MOBIL OIL DTE 26 DTE 24
IPIRANGA IPITUR AW-68 IPITUR AW-46
PETROBRÁS MARBRAX TR-68 MARBRAX TR-46
TEXACO REGAL R & O - 68 REGAL R & O – 46
Table 9 – Oil specifications
Oil Level