5 Installation at Site
16 of 32
AmaSlide
2553.870/01-EN
5.3 Installing a pump set with AmaSlide
Install the pump set as described in the pump's installation/operating manual.
183
901.26
920
920
Fig. 3:
Installed pump set / Removing the support foot
ü
The pump set has been installed as shown.
ü
The suction-side and discharge-side piping has been connected to the pump.
ü
The (optional) flanged spacer has been fitted on the suction side.
1. Undo nut 920
2)
from both chemical anchors at support foot 183.
2. Undo hexagon head bolt 901.26 at the motor cover.
3. Remove support foot 183.
183
901.26
Fig. 4:
Positioning the support foot
4. Position support foot 183 as shown.
5. Position hexagon head bolt 901.26 at the motor cover but do not tighten it yet.
2)
Component part of chemical anchor, not included in maintenance aid scope of supply
