Krups Espresso Vivo, Instructions For Use Manual

Page: 10 / 16

Step 2
Insert the filter holder (without espresso)
into the brewing head. Do this by raising
the filter holder up into the machine at a
45 degree angle (figure 4).
Place at least a 5 oz. cup directly under
the filter holder (see figure 5).
n
Make sure the pump switch is in the ‘off”
position. Using the ON/OFF button, turn
“on” the appliance fig. 6
The two indicator lights, yellow and red, will
illuminate. Some water may drip out of the
brewing head during the heating period.
This is normal.
n
Set the pump switch to the position
(see figure 6).
This will activate the pump. Upon first use,
the boiler will need to intake water
into the boiler chamber, and You will hear a
distinct initial thumping noise.
As soon as water is released from the filter
holder, turn the pump switch back to the
“off” position to allow the unit to reach the
proper temperature.
Step 3
As soon as the yellow (thermostat) light
goes out, the machine is properly heated
and ready for use.
Set the pump switch to the position
and let water run into cup, stopping and
starting water flow by using the pump
switch (see figure 9).
Repeat this process until half of the water in
the water reservoir has been used.
This will require you to stay with the
machine to empty each cup as it becomes
full. Upon completion of each cup set pump
switch to the “off” position.
Espresso is a far richer and stronger brew
than regular coffee. It should be deep, dark
and delicious. Most people find they enjoy it
in small quantities because of its richness
and for that reason, espresso is usually
served in small
oz. demitassse cups.
The mark of real espresso is its wonderful
inviting fragrance and a light brown
“Crema”, found on top of the surface of the
coffee. Your “Espressso Vivo”, properly
used, will always produce espresso that is
deep, dark, and delicious. Just follow the
instructions and use fresh, well roasted
espresso beans.
If you choose to grind your own beans we
recommend using the KRUPS II Barista
Remember, espresso requires a much finer
grind than regular coffee. We recommend
grinding your espresso beans for
approximately 60 seconds; or until it has a
talcum powder appearance and texture.
Before you make Your first cup of delicious
espresso, make sure that the boiler chamber
has water.
With the water reservoir full, place a cup
directly under the filter holder. Turn “on” the
unit and set the pump switch to As soon
as water begins to flow from the filter
holder, the boiler is full. Set the pump
switch back to the ‘off’ position. When the
yellow thermostat light goes off, you are
ready to make espresso.
Making Espresso
Step 1
n
Fill the water reservoir with fresh, cold
water (figures I-3).
While making espresso, water can be added
to the reservoir by opening the hinged
water chamber lid and adding water to the
10