Krups EA819 ARABICA LATTE, Manual

Page: 35 / 379

33
EN
The grinder produces an abnormal noise. Foreign bodies are present in the grinder.
There is some water or coffee under the
appliance.
The drip tray has overflowed: empty it and clean the coffee grounds
collector tray. Check the proper positioning of the drip tray.
Do not remove the reservoir before the end of the cycle.
The appliance did not output any coffee.
An incident was detected during preparation.
The appliance has automatically reset itself and is ready for a
new cycle.
You used ground coffee instead of coffee
beans. Using your vacuum cleaner, vacuum the pre-ground coffee
contained in the bean reservoir.
The grind fineness setting knob is hard to
turn.
An incident was detected during preparation.
The appliance has automatically reset itself and is ready for a
new cycle.
Some water or steam abnormally comes
out of the steam nozzle. Using your vacuum cleaner, vacuum the pre-ground coffee
contained in the bean reservoir.
The grind fineness setting knob is hard to
turn.
Only modify the setting of the grinder when it is in operation.
Foreign bodies are present in the grinder: contact the KRUPS
customer service department.
Some water or steam abnormally comes
out of the steam nozzle. In the case of repeated operation, a few drops may flow out of
the steam nozzle.
The steam outlet of your cappuccino
system seems to be partially or completely
blocked.
Start the cappuccino system’s rinse cycle to clear out the rest of
the deposits.
Clean the steam outlet and check that the nozzle hole is not
obstructed by milk residues or limescale. Use the cleaning
needle if necessary.
Some ground coffee is found in the drip
tray.
This occurs in cases where the coffee grounds fall outside of the
percolation vat: this maintains the cleanliness of the inside of the
machine.
After having emptied the coffee grounds
collector tray, the warning message
continues to be displayed.
Wait at least 6 seconds before properly reinstalling the coffee
grounds collector tray.
After having filled the water reservoir, the
warning message continues to be displayed
on-screen Check the proper positioning of the reservoir in the appliance.
The float in the bottom of the reservoir must move freely. Check
the float and unblock it, if necessary.
The machine is not requesting any
descaling. The descaling cycle is requested due to a large number of uses
of the steam circuit.
USE
M
AINTENANCE
KR_ARABICA-LATTE_EA819_8020002251_EN.qxp_Mise en page 1 17/08/2018 14:02 Page33