Krups EA8150, Manual

Page: 6 / 36

6
TROUBLESHOOTING
GUARANTEE
Possible problems Probable causes Corrective actions
The appliance will not start,
the ON/OFF button flashes. The temperature of the jug
is too high Wait for the light to stop
flashing and press the
ON/OFF button again
The stirrer is blocked Empty out the milk, remove
the stirrer and clean your
jug and stirrer.
Water has leaked into
the base of the appliance
during cleaning. Leave to dry 24 hours.
The appliance is not
frothing. The stirrer is missing or is
not positioned correctly. Empty out the milk and
reposition the stirrer.
Motor operates intermittenly
during entire frothing
process. Water has leaked into
the base of the appliance
during cleaning. Leave to dry 24 hours.
This product has been designed for domestic use only. Any commercial use, inappropriate
use or failure to comply with the instructions, the manufacturer accepts no responsibility
and the guarantee will not apply.
If you have any questions, please contact the customer service of your country. It is
preferable to have the appliance close to hand when calling, as well as the serial number
marked on the bottom of the appliance.
If you have any problem problems or queries, please contact our Customer Relations Team
first for expert help and advice:
0345 330 6460 - UK, (01) 677 4003 - Ireland, or consult our website - www.krups.co.uk
This product contains an electronic board in the base, any introduction of water or other
liquid in this part could damage the product. In this case the guarantee will not apply.
If the problem continues, please contact the service centre in your country.
CLEANING: DO NOT CLEAN THE APPLIANCE
IN A DISHWASHER
The non-stick coating on the inside of the jug means that you can clean it easily. Here’s how
to go about it: Unplug the appliance.
1. Remove the stirrer from the jug
(fig 4) .
2. Clean the jug using warm water and washing-up liquid with a sponge or a non-abrasive
cleaner (fig 5) .
3. Never immerse the appliance in water or put it under running water
(fig 6)
.
4. Dry the appliance.
Remember to fit the stirrer again, ensuring that it is clipped into place.