Krüger & Matz KM0534, Owner'S Manual

Page: 7 / 16

7
Owner’s manual
EN
NOTICE
CONNECTION
• DO NOT expose this appliance to humidity, water or any other liquid.
• The appliance should be connected to a power supply as per specification in the
operating instructions or as marked on the appliance.
• Place the device in a properly ventilated and dust free place.
• Protect the device from extreme temperatures, sources of heat and direct sunlight.
• Clean the unit’s exterior periodically with a soft, slightly damp cloth. Never use
chemical agents to clean this device.
• Disconnect this device from power supply if it is not going to be used for a long
period of time.
• Do not disassemble the device. In case of damage, contact with an authorized
• service point for check-up/repair.
• Power cord protection: power-supply cords should be routed so that they are not
likely to be pinched by items placed upon or against them. Pay particular attention
to cords, plugs, and power sockets and the point where they exit from the appliance.
• Do not exceed the maximum input power of the speaker system.
Attention: the two pieces of the metal wire of the cable should never touch each other.
Red terminal
Black terminal
1. Strip the wire from isolation
(~10 mm), then tighten the
wire by hand in order to settle
its protruded places and avoid
short circuit.
2. Release the copper post in
counter clockwise direction,
and put the copper wire into
the hole.
3. Tighten the copper post in
clockwise direction, gently pull
the wire, and make sure the
pieces are connected firmly.
Connection to
corresponding
"+" pole of the
amplifier
Connection to
corresponding
"-" pole of the
amplifier