Settings
43
Pos : 22.7 /Übersc hrift en/Übersc hrift en 2/A-E/Ei nst ellung der Entlas tungsf edern @ 0\ mod_1196666659447_78.doc x @ 10133 @ 1 @ 1
9.2
Adjusting the Compensation Springs
Pos : 22.8 /BA/ Sicher heit /G ef ahr enhi nweis e/M ähwer ke/G ef ahr - Ei nst ellung an den Entl ast ungs feder n @ 0\ mod_1196751594562_78. doc x @ 12575 @ 2 @ 1
Danger! - Setting on the compensation springs
Effect: Danger to life or serious injuries
•
The compensation springs must only be removed in transport position. In the working
position the compensation springs are subject to high tensile stress.
•
Severe injury can be caused if the compensation springs are removed while in the
working position.
•
The lower threaded blocks on the compensation springs must be fully screwed in.
Pos : 22.9 /BA/ Eins tell ung en/Mähwer ke/ Eas yC ut/ Bodendruc k/ Bodendruc k allgemeiner T ext all e EC @ 0\ mod_1196667271181_78. doc x @ 10190 @ 1 @ 1
The ground pressure for the cutter bar is adjusted to local conditions by means of the
compensation springs. In order to protect the sward the load on the mowing spar must be
relieved so that it does not jump when mowing, yet does not leave any skid marks on the
ground.
Pos : 22.10 / BA/Ei nst ellungen/M ähwer ke/ Eas yCut/Entl ast ungsfeder(n)/Entl ast ungsfeder Bil d Ec 280/ 320 -1 @ 58\ mod_1296731267645_78. doc x @ 553597 @ @ 1
Fig. 22
Pos : 22.11 / BA/Ei nst ellungen/M ähwer ke/ Eas yCut/Entl ast ungsfeder(n)/Ei nst ellung Entl ast ungsfeder Hinweis EC 320 -1 @ 58\ mod_1297066797720_78. doc x @ 554982 @ 22 @ 1
Note
To adjust the compensation springs, move the disc mower to transport position. This is the only
position in which the bolt (1) can be moved in the pattern of holes to change the spring pre-
tensioning of the compensation springs.
Pos : 22.12 / BA/Ei nst ellungen/M ähwer ke/ Eas yCut/Entl ast ungsfeder(n)/Entl ast ungsfeder Positi on a/b @ 9\ mod_1220960075381_78.doc x @ 130208 @ @ 1
Position "a" = lowest compensation
Position "b" = highest compensation
Pos : 22.13 / BA/---------------Seitenumbr uc h---------------- @ 0\ mod_1196175311226_0.doc x @ 4165 @ 3 @ 1
Summary of Contents for EasyCut R 280
Page 85: ......
