Krone Comprima F 155 XC, Original Operating Instructions, Page: 173 / 278

Settings 17
Checking and setting the position of the feed rocker arm 17.4
Comprima F 155 XC
Original Operating Instructions 150001050_01_en 173
The feed position has been optimally set when the distance between the feed rocker arm (1)
and stop (2) is
X=3–5 mm . As a result, the wrapping material is optimally accepted by the round
bale.
„
Move the feed rocker arm (1) to the saved feed position on the round bale.
„ Switch off the tractor, remove the ignition key and take it with you.
„
Check whether there is a distance of X=3–5 mm between the feed rocker arm (1) and the
stop (2).
If the distance is not X=3–5 mm , set and save the feed position again as follows:
„
Start the tractor.
„
Move the feed rocker arm in the direction of the feed position until the feed rocker arm (1)
has approached the stop (2) up to a distance of
X=3–5 mm .
„
Save the new position.
17.4.2 Checking and setting end position for chamber film wrapping
1
2
3
RP000-028
The end position has been optimally set, with chamber film wrapping activated, when the feed
rocker arm (1) is in the end position on the insulation of the pressure shaft (2). As a result, the
film is clamped and held in position.
„ Open menu 10 "Manual operation" on the terminal, refer to page 146 .
„
Move the feed rocker arm (1) to the saved end position.
„ Switch off the tractor, remove the ignition key and take it with you.
„
Check whether the conical roller (3) is positioned on the insulation of the pressure shaft (2)
and whether the film jams between the insulation of the pressing shaft (2) and the conical
roller (3).