Krone BiG Pack 870 HDP XC, Original Operating Instructions

Page: 222 / 410

15 Settings
15.19 Setting packer relative to plunger
222
BiG Pack 870 HDP XC
Original Operating Instructions 150000760_00_en
15.19.3 Positioning the plunger
BPG000-046
ü The machine is shut down and safeguarded, refer to page 25 .
„
Positioning the packer strip, refer to page 221 .
„ Remove the protection (6) of the chain coupling.
„
Remove the roller chain (7) from the chain coupling.
„ Release flywheel brake, refer to page 89 .
„
Turn the flywheel (13) in working direction ( refer to page 111 ) until the piston rod is in its
extended position (I) (rear dead point).
„ Apply flywheel brake refer to page 89 .
„
Put the roller chain (7) on the chain coupling and secure it.
„ Mount the protection (6) on the chain coupling.
„
Remove the mounting lever.
Checking the setting
„
Release flywheel brake, refer to page 89 .
„
Turn the flywheel (13) into working direction ( refer to page 111 ) until the piston rod is in its
extended position (I) (rear dead point).
The packer (10) is correctly set to the plunger (9) if the piston rod (8) is in extended position (I).
At the same time, the large roll on the packer strip (11), which runs in front of the feeder strip
(12), must be in the range
of 30–60 mm under the inspection window (5).
If the dimension is not set correctly, start carrying out the settings from the beginning, refer to
page 219 .