Terminal – Machine functions
13
Setting target bale length 13.24
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en
155
13.24
Setting target bale length
INFORMATION
The target bale length (2) can be changed steplessly at any time. It is not recommended to
switch over the target bale length at the end of the bale, as the knotter could actuate too late.
20
4 cm
38 %
94 /
240
cm
2 /
4
2
1
EQG000-032
Value (1) and the bar display = actual bale length
Value (2) and the red mark on the bar display = set target bale length
Setting target bale length
Setting range: 1,000 - 2,700 mm/39 - 106 inch
Change value,
.
13.25
Setting the target number of MultiBales
INFORMATION
To prevent a mixture of entire bales and MultiBales, set the target number (2) of MultiBales
always at the start of an entire bale.
20
4 cm
38 %
94 /
240
cm
2 /
4
20
4 cm
108 bar
94 /
240
cm
2 /
4
2
2
1
1
EQ001-057
Value (1) = actual number of MultiBales
Value (2) = set target number of MultiBales
Setting the target number
ü
The bale length has been set,
Change value,
.
