GB-3
D
GB
F
NL
I
E
Installation
CAUTION
Please observe the following to ensure that the
JSAV is not damaged during installation:
– Sealing material, cuttings and other impurities
must not be allowed to get into the housing.
– We recommend installing a filter upstream of the
JSAV, in order to protect it against impurities in
the pipe.
– The installation location must be dry. Do not
store or install the JSAV in the open air.
– Install the JSAV in the pipe free of mechanical
stress.
– Do not clamp the unit in a vice or use it as a
lever. On the JSAV..R, only secure the valve by
holding the octagon at the inlet or outlet with a
suitable spanner. Risk of external leakage.
– Max. inlet pressure p
e max.
4 bar (58 psig).
– Installation in the vertical or horizontal position,
never upside down.
1
The housing must not be in contact with masonry.
Minimum clearance 20 mm (0.78"). Ensure that
there is sufficient space for installation and adjust-
ment.
2
JSAV..R: seal pipe with approved sealing material.
JSAV..F: insert seal between pipe and unit.
Remove screw caps or adhesive foil from the inlet
and outlet on the JSAV.
▷
▷
Note direction of flow.
JSAV 25 – 40
JSAV 50 –100
▷
▷
We recommend installing a manual valve AKT 25
in the pipe leading to the safety relief valve
VSBV 25, so that the annual function check of
the safety shut-off valve JSAV can be carried out
without having to remove it.
▷
▷
To prevent the VSBV from being unintentionally
shut off, we recommend removing the manual
valve lever after commissioning and attaching
it to the pipe.
JSAV
Connecting the impulse line
JSAV 25 – 40
▷
▷
The connection flange is suitable for an impulse
line with a pipe diameter of 8 mm.
2
1
3
4
Push union
nut and
compression
fitting onto
the impulse
line.
▷
▷
On the JSAV..T, remove the blind plug and con-
nect an NPT
1/8
impulse line.
JSAV 50 – 100
▷
▷
Remove the blind plug and connect an Rp ¼
(NPT ¼) impulse line.
JSAV
5
Install the impulse line and seal with an approved
sealing material.
▷
▷
Ensure that there is sufficient tube length for the
impulse line.
_> 5DN
JSAV
