1
ULTIMATE 300KS Mk2 39%
Assembly Guide
Dear customer,
thank you for choosing ULTIMATE 300KS Mk2 39% model airplane.
Original kit Ultimate 300 KS was developed by our team for patern and 3D flying too. Kit has had
great flying characteristics, but not sufficient for top competitive flying. We decided to improve it‘s
flying characteristic and in cooperation with great Italian pilot Sacha Checconi was created new
version Mk2 built on strong base of current kit and test it with our pilot Marek Plichta.
And what are the differencies?
At first, we put close together top to bottom wing and engine axis is now right in the middle of the
wings. At second we enlarged ailerons on all wings at depth and lenght too, overall area is now
bigger to original more than 60% ! Kit gets uncredible flying agility also during harier tricks. We
also decreased overall weight at the same time reinforced wings (new wing spar) for higher drain
during aggresive 3D flying . New is fixing of cabane inside the fuselage, new interplane struts , new
holder of tanks and already instaled rudder servo tray. Holder of main landing gear is also
redesigned, Gabriel horns are used on all control surfaces, as well as new builder friendly servo
fixing on the wings.
The ULTIMATE 300KS Mk2 kit is a full composite biplane kit, with main top wing from one piece
and bottom wings a horizontal stabilizator spar made from carbon fibre tubes. Both wings and
horizontal stabilizator can be easily removed for transporting. Tail control surfaces has central
hinges.
Content
page
1.
Technical data............................................................................................................................2
2.
General informations.................................................................................................................2
3.
Setting and setup .......................................................................................................................3
4.
Recommended servos ...............................................................................................................4
5.
Assembly ...................................................................................................................................4
5.1
Empenage ....................................................................................................................4
5.1.1
Rudder ..........................................................................................................4
5.1.2
Horizontal stabilizator ..................................................................................5
5.1.3
Elevator ........................................................................................................6
5.2
Wing assembly ............................................................................................................7
5.2.1
Servo install..................................................................................................7
5.2.2
Linkage .........................................................................................................8
5.3
Fuselage...................................................................................................................... 9
5.3.1
Rudder drive linkage .................................................................................. 9
5.3.2
Engine installation .....................................................................................10
5.3.3
Fuel & Smoke Tank installation ................................................................11
5.3.4
Equipment installation................................................................................12
5.4
Landing gear..............................................................................................................12
5.4.1
Main landing gear.......................................................................................12
