13
EN
Troubleshooting
If your Mission
TM
does not work correctly, follow the trouble shooting guide below. If the fault persists, contact
your dealer.
Symptom
Cause
Solution
The LED light on the charging
base does not turn on.
There is no power.
Check the charging base is connected
properly to the charger and the charger
is connected to a suitable power supply.
Green light flashing on the
charging base.
The boundary wire isn’t
connected.
Check that the boundary wire has been
connected correctly to the charging base.
Check there are no breaks in the
boundary wire, especially in the wire ends.
Your Mission
TM
is inside its
working area but the display
says “outside working area”
and the LED is green.
The boundary wire ends are
clamped incorrectly.
Reverse the boundary wire ends.
Mission
TM
cannot correctly
dock with the Charging base.
Environmental influences.
Restart Mission
TM
.
Poor connection caused by
debris on the charging strip.
Clean the contact pins located on the
charging base and the charging strip on
Mission
TM
using a cloth.
Mission
TM
runs outside the
boundary wire. Mission
TM
does
not mow an area within a
boundary wire zone. Mission
TM
reverses or rotates erratically
near the boundary wire.
The boundary wire of another
Mission
TM
or another branded
robotic mower is positioned too
closely.
Ensure your Mission
TM
boundary wire
has at least 1m of spacing between the
neighboring boundary wire.
The boundary wire has been
installed with acute angles.
Check the boundary wire to ensure the
angles are smooth.
In wet conditions, the boundary
wire electric signal may leak
where wire has been joined or
repaired.
Check boundary wire joints. Insulate to
provide a fully waterproof connection.
There is boundary wire electric
signal leakage due to broken
insulation.
Repair damaged boundary wire
insulation with insulation tape.
The cutting area is larger than
the allowable cutting area for
Mission
TM
.
Decrease the cutting area.
Mission
TM
exits the boundary
wire due to high speed when
going down a hill.
The boundary wire is placed on
a slope steeper than 17% (10°).
Reposition the boundary wire away from
slopes that are steeper than 17% (10°).
Environmental protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
