Kremlin-Rexson XCITE AIRMIX, Manual

Page: 56 / 63

KREMLIN REXSON - 1 - N° : 578.002.120-UK-1206
START-UP
Safety instructions :
x
Never try to stop the spray fan with any part of the body (hands, fingers…) or with
rags. Never point the spray gun at anyone or at any part of the body.
x
The operator will need medical attention if the high pressure material spray is in
contact with the the body (eyes, fingers…).
x
Always lock the gun trigger with the safety device when not operating the gun.
x
Always depressurize air and hoses
before carrying out any servicing on the gun.
In order to protect the operator, protective clothing (gloves, hearing
protective earplug, respirator mask, glasses, clothes…) are required.
Use the equipment in a properly ventilated area.
1 - Prepare the paint (blend and filter the paint to the appropriate viscosity - refer to the material
technical data).
2 - The air supply to the equipment must be (clean dry air, maximum air pressure = 6 bar / 87 psi)
3 - Prime the pump (refer to pump instruction manual).
4 - Unlock the safety device to release the gun trigger. Point the gun into a waste container and and
open the gun by using the trigger until clean material flows.
5 - Lock the safety device.
6 - Select a spray nozzle (refer to AIRMIX ®.nozzle chart).
7 - Make sure white seal or micro-filter is in place in the spray nozzle.
8 - Install the spray nozzle inside the air cap being certain the locating pins are aligned with mating
recesses of the nozzle.
9 - Insert the air cap with its nozzle into the retaining ring. Screw retaining ring and air cap firmly onto the
spray gun positioning the air cap to obtain the desired pattern orientation.
10 - Unlock the safety device and trigger the gun.
11 - Adjust the pump air pressure (red regulator) for the desired flow rate.
NB: Increase fluid pressure until the spray fan is correct. Stop adjustment when the spray fan is
giving the best results.
12 - Adjust spraying air pressure (grey regulator) until the pattern is even.
NB: The drawing shows the relation between fan pattern and spraying air pressure.
No air Not enough air Spraying air correct
¾
To optimize Airmix
£
spraying , do not increase spraying air pressure once the correct fan is
obtained. It would lead to more spraying mist.