To Install the Spikes on the LAT–1
Each LAT–1 is shipped with 4 stainless steel spikes: two rear articulating spikes
(with knob) and two (one long and one short) front stationary spikes (no knob). Use
these spikes to stabilize and level the loudspeaker. These spikes are particularly
important for sound quality if the loudspeaker will be placed on a carpeted floor.
The longer front spike is for deep-pile carpeting.
IMPORTANT
Do not install spikes until the loudspeaker has been placed in the listening area.
1.
Insert the rear articulating spikes (with knobs) into the holes provided on the back
of the loudspeaker base.
2.
Turn knobs by hand until they are secure (do not over-tighten).
3.
Tilt the loudspeaker back just enough to insert the front stationary spike (no knob).
IMPORTANT
Two people are needed to safely tilt the loudspeaker to install the front stationary
spike.
4.
Turn the front spike by hand until it is secure (do not over-tighten).
5.
Place the bubble level on the loudspeaker cap.
6.
Adjust the rear articulating spikes until the bubble indicates the loudspeaker is
level.
To Install the Foot, Leg, and Pivot Mechanism on the LAT– C
1.
Bolt the socket head cap screws through the screw holes on the foot and into
the right leg.
2.
Insert the shoulder screw through the right shoulder screw hole on the right leg
and into the pivot hole on the right cap and hand tighten.
3.
Move to the left side and repeat steps 1 and 2, to install the left leg and left
shoulder screw.
4.
Adjust the angle of the LAT– C and insert the locator bolt through the leg and into
the locator hole in the cap, one side at a time.
13
