Back Panel Description
See Figure 2 on page 9
10
Krell KAV–300iL
The KAV–300iL back panel provides connections for all inputs and
outputs, power on/off, and additional remote connections.
12 Left and Right Loudspeaker Outputs
The KAV–300iL is equipped with standard binding posts for each
amplifier channel. These connectors accept bare wire, pins, or
spade lugs. Use the red terminal for the positive connection and
the black terminal for the negative connection.
13 Left and Right Balanced Analog Inputs
The KAV–300iL is equipped with one pair of balanced (B-1) inputs
via XLR connectors.
14 Left and Right Single-Ended Analog Inputs
The KAV–300iL is equipped with three pairs of single-ended (S-1,
S-2, or S-3) inputs via RCA connectors.
15 Left and Right Tape Inputs
The KAV–300iL is equipped with a pair of single-ended tape inputs
via RCA connectors.
16 Left and Right Tape Outputs
The KAV–300iL is equipped with a pair of single-ended tape
outputs via RCA connectors.
17 Left and Right Preamp Outputs
The KAV–300iL is equipped with a pair of single-ended pre-
amplifier outputs.
18 RC-5 In
The KAV–300iL is equipped with an RC-5 input that makes custom
installation easy and secure by accepting baseband RC-5 input
commands from hardwired remote controllers.
19 12 VDC Out
The KAV–300iL is equipped with an output that sends 12 VDC
(12 V trigger) power on/off signals to other Krell components and
other devices that incorporate a 12 V trigger. This allows you to
turn other components on or off, or to and from stand-by, from the
KAV–300iL. When the KAV–300iL is switched between stand-by
and operate, it sends a signal from the 12 VDC Out that will switch
other components, allowing whole systems or parts of systems to
be easily coordinated.
AMPLIFIER CHANNEL
OUTPUTS
ANALOG INPUTS
ANALOG OUTPUTS
REMOTE
CONNECTIONS
