Krell FBI
19
22 RC-5 In
The FBI is equipped with an RC-5 input that makes custom instal-
lation easy and secure by accepting baseband RC-5 input com-
mands from hardwired remote controllers.
23 12 VDC In / Out (12 V Trigger)
The FBI has one output that sends, and one input that receives 12 VDC
power on/off (12 V trigger) signals to and from other Krell components,
and other devices that incorporate a 12 V trigger. This allows you to
turn other components on or off, or to and from stand-by. When an
amplifier is switched to operational mode and is connected to other
components through the 12 V trigger, it sends a signal that will switch
other components, allowing whole systems or parts of systems to be
easily coordinated. Mono 3.5 mm connectors are used in the following
configuration: Tip = +12 V, Sleeve = GND.
When the FBI is in the operational mode, the 12 V trigger provides 12 Volts
of DC output. When the FBI is in the stand-by mode or off, the DC output
is 0 Volts. A maximum of 30 mA is available from the 12 V trigger output.
Consult the owner's reference of the components used in a custom instal-
lation to take full advantage of the remote capabilities of the FBI.
24 Back Panel Power Breaker Switch
Place the back panel power breaker switch in the up position to
put the FBI in stand-by mode. Krell recommends that the amplifier
remain on, in stand-by mode, when not in use.
25 IEC Connector
The connector is for use with the provided AC power cord.
26 Handles
The FBI is equipped with two handles to help to move the inte-
grated amplifier easily and safely.
Notes
REMOTE
CONNECTIONS
CONVENIENT
LIFTING DEVICE
POWER
