Round over the edges
Once the glue in the top/dowel holder assembly is dry use a roundover bit mounted in a router table to shape the outside
edges of the assembly. How large you make the roundover is a matter of personal taste. I usually use a 1/2" radius bit set to a
very shallow cut. You can now sand the assembly. I start with 100 grit and end with 150 grit sandpaper.
Mortising the bottom
Using the following diagram draw the mortise positions and dimensions on the bottom board. Rough cut the mortises
using a drill press with a 1/4" drill bit. Then use chisels to clean up and finish the cut. Alternatively you can use a mortising
machine, if one is available, or a router if you have the proper bit and template.
9
10
Page 8 of 11