18
U73020-00B
KRAUSMANN POWER TOOLS
English |
EN
5. Maintenance
Correct and regular cleaning will improve the safe-
ty and extend the lifespan of the device.
For safe and proper working, always keep the
tool and ventilation slots clean.
Τhe tool may be cleaned most effectively with
compressed dry air.
Always wear safety goggles
when cleaning tools with compressed air.
Certain cleaning agents and solvents damage
plastic parts.
Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents,
ammonia and household detergents that contain
ammonia.
Store the tool, operating instructions and where
necessary the accessories in the original packag-
ing. In this way you will always have all the informa-
tion and parts ready to hand.
Wear ear defenders
Wear safety goggles
WARNING:
T
urn the device off, disconnect it from the mains and wait
until it cools down before cleaning or maintenance to
avoid electric shock or burn.
Wear a dust mask
This tool has been checked by the manufacturer.
From the date of purchase by the final consumer,
a two year warranty for
amateur use
covers any
faulty material and manufacturing. The receipt or
invoice of purchase needs to be displayed in case
of a repair that is covered by the warranty. For
possible faults during the warranty period, you
should address your issue to the retail shop from
which the purchase was made.
6. Warranty
Terms of warranty
The tool has been used properly and for the
purpose for which it was purchased.
T
he tool presents a problem that is due to
faulty material and manufacturing.
I
ncapability of the tool to perform according
to the technical specs provided.
Damages are not covered by the warranty that are
due to causes such as:
W
ear due to improper use.
Partial or total disassembly.The tool’s shell
must be disassembled only by personnel
authorised by the official distributor.
Damage due to overloading.
Usage of incorrect or incompatible accessory.
Bad maintenance from the operator or any
other third party.
W
ear that was induced by external factors or
rogue particles (dust, debris etc.)
W
ear due to non compliance with the instruc-
tions in this manual.
I
f, during the warranty period, there is a fault that
can not be repaired from the authorised service
department, the tool will be replaced without any
extra cost.
The warranty is valid only when:
In case there is a need for a repair after the war-
ranty period has expired, we will provide the best
possible attention to repair the tool successfully.
7. Repair / Servicing
ture is meant for controlled loosening of lug nuts
without backing fully off the stud. Uncontrolled
spinning can damage the treads on the end of the
stud or bolt. To disengage break just push the
″B″ button one more time and the red LED will
turn off. Your tool is again in the full reverse mode.
NOTE:
Both reverse functions only operate with the electronic
clutch in the third speed position. This feature is
unavailable in speed one and two.
i
