18
9851
KRAUSMANN POWER TOOLS
5
English |
EN
7. Maintenance
selector switch
2
to the position shown (fig 3).
Hold the tool firmly with both hands. Turn the tool
on and apply slight pressure on the tool so that the
tool will not bounce around, uncontrolled. Pressing
very hard on the tool will not increase efficiency.
For safe and proper working, always keep the
tool and ventilation slots clean.
Τhe tool may be cleaned most effectively with
compressed dry air.
Always wear safety goggles
when cleaning tools with compressed air.
Certain cleaning agents and solvents damage
plastic parts.
Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents,
ammonia and household detergents that contain
ammonia.
T
he brushes and commutator in your tool have
been engineered for many hours of dependable
service. To maintain peak efficiency of the motor,
we recommend every two to six months the
brushes be examined.
A
damaged dust cup should be replaced
immediately.
We recommend having this carried
out by an after-sales service professional.
Store the tool, operating instructions and
where necessary the accessories in the original
packaging. In this way you will always have all the
information and parts ready to hand.
First set the mode selector switch
3
and the mode
selector switch
2
to the position shown (fig 4).
Use the drill metallic chuck with SDS-plus adaptor
assembly
(not included)
(fig 10), you can drill up to
13 mm (1/2”) diameter in metal and up to 40 mm
(1-9/16”) diameter in wood.
Drilling operation
fig 10
Metallic chuck with SDS-plus
adaptor assembly (not
included)
WARNING:
N
ever use “Hammer drilling” when the drill chuck
assembly is installed on the tool. The drill chuck assembly
may be damaged.
P
ressing excessively on the tool will not speed up the
drilling. In fact, this excessive pressure will only serve to
damage the tip of your bit, decrease the tool performance
and shorten the service life of the tool.
There is a tremendous and sudden twisting force exerted
on the tool / bit at the time of hole breakthrough. Hold
the tool firmly and exert care when the bit begins to break
through the workpiece.
A
lways secure small workpieces in a vise or similar hold-
down device.
This tool has been checked by the manufacturer.
From the date of purchase by the final consumer,
a two year warranty for
amateur use
covers any
faulty material and manufacturing. The receipt or
invoice of purchase needs to be displayed in case
of a repair that is covered by the warranty. For
8. Warranty
Wear ear defenders
Wear safety goggles
Wear a dust mask
Hammer drilling
Chiselling
Drilling
SDS-plus chuck
SDS
plus
Max. drilling capacity in concrete
Ø 26mm
26
mm