9
Step 6: Flush faucet
Pull the hose assembly out of the spout and
remove the spray head (A) by unscrewing it
from the hose in a counterclockwise
direction. Be sure to hold the end of the hose
down into the sink and turn the faucet on to
the warm position where it mixes hot and
cold water. Flush the water lines for one
minute. This flushes away any debris that
could cause damage to internal parts. Check
for leaks. Re-tighten any connections if
necessary, but do not overtighten. Reinstall
the spray head (A) by hand tightening it
back onto the sprayer hose.
After installation is completed, turn on the
hot and cold water supplies. Check for leaks.
NOTE
: Please make sure washer is
installed attaching sprayer to hose.
A