7
Step 2. Dishwasher Connection
EZ Mount System
SINK FLANGE
RUBBER WASHER
FIBER WASHER
MOUNTING NUT
MOUNTING RING
TIGHTENING EARS
MOUNTING SEAL RING
If you are utilizing a dishwasher, complete the following procedure. If dishwasher is not to be connected
go on to section 3.
A.
Make use of a blunt instrument to knock out the housing cap(see 2A1), please sure to use a steel
punch or wooden dowel but not sharp instrument. Punch the cap with force and remove the fell
off cap(see 2A2). Use the blunt instrument again to knock the plug on the inner body(see 2A3).
Please take out or grind the knockout plug if it falls into the chamber.
B.
Connect dishwasher hose using hose clamp. If hose size is different, you will need a Dishwasher
Connector Kit (see 2B). Make sure all plumbing connections are tight and in accordance with all
plumbing codes and ordinances. Run water and check for leaks.
*AIR GAP
DISPOSER
RUBBER
HOSE
DISHWASHER
HOSE
*Air gap may not be required for all
installations. Check local plumbing codes.
Step 3. Installation of Mounting Assembly
Your disposer comes with the EZ Mount System.
2B
MOUNTING SCREWS
2A
CAP
OUT
KNOCK
2A1
2A2
2A3
PLUG
OUT
KNOCK
