16
Manual
www.kraun.it
4.1.2.2 P2MP Bridge Mode
The P2MP Bridge Mode which connects scattered wired network together is more complicated than P2P Bridge
mode. P2MP usually transmit wireless signals from one access point, and other access points are in charge of
receiving signals so as to share network resource. Support up to 4 remote access point connection. In this mode,
wireless clients are not allowed to connect.
P2MP Bridge mode can connect multiple wireless access point together without cabling. If “Root AP” is config-
ured as P2MP bridge mode, other (less than 4) remote access points should select P2P bridge modes. The topol-
ogy shows below:
Modem
Ethernet
Switch
Select WDS P2MP mode in the drop-down box of WDS mode as the picture below.
h
h
APhMAChAddress:
Input the remote AP’s MAC address. (No more than 4)
h
h
Channel:
Select the channel which bridge needs to use. (All APs in the bridge must be at the same channel.)
h
h
EnablehScan:
Click this button, the AP will scan the nearby wireless devices automatically and display the
information in the table. Select the device which need to bridge, the AP will add the device’s MAC address
automatically and select the corresponding channel. When multiple devices are added, AP will select the
channel of the last added device as the bridge used channel (You can also change the channel according to
your need. All the devices must at the same channel, thus the bridge can be established.)
Summary of Contents for KR.KZ
Page 35: ...35 Manual www kraun it ...
