Yarden 6-OD - Installing the Yarden 6-OD
7
3. Pass the speaker wires through the round hole in the mounting bracket (see
Section
4.3
).
4. Adjust appropriate tap setting (see
Figure 3
).
Set the tap according to the power requirements of the speaker based on its location in the
room (for example, a speaker located in a remote corner may require additional power)
Figure 3: Adjust Tap Selector
Stereo Setup (see
Figure 2
)
Mono Setup (see
Figure 7
)
5.
Set the selector switch to STEREO.
Set the selector switch to MONO.
6.
On the L terminal block, connect one
of the + and
– terminal block pairs on
the rear panel (see
Figure 1
) by
connecting the
wire from the:
Negative left terminal on the
receiver into the negative
terminal block of the speaker
Positive left terminal on the
receiver into the positive
terminal block of the speaker
On the L terminal block, connect one
of the + and
– terminal block pairs on
the rear panel (see
Figure 1
) by
connecting the
wire from the:
Negative terminal on the
receiver into the negative
terminal block of the speaker
Positive terminal on the
receiver into the positive
terminal block of the speaker
7.
On the R terminal block, connect
one of the + and
– terminal block
pairs on the rear panel by
connecting the
wire from the:
Negative right terminal on the
receiver into the negative
terminal block of the speaker
Positive right terminal on the
receiver into the positive
terminal block of the speaker
