WP-EN6
Quick Start
P/N: 2 9 0 0 - 3 0 1 3 2 8 QS
Rev: 2
Scan for full manual
WP-EN6 Quick Start Guide
This guide helps you install and use your
WP-EN6
for the first time.
www.kramerav.com/downloads/WP-EN6
to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check
what’s in the box
WP-EN6
Video Encoder
1 Quick start guide
Installation accessories
Frame (or frame set) and faceplate
Step 2: Get to know your WP-EN6
FRONT PANEL
BACK PANEL
#
Feature
Function
1
IR TX on a 3.5mm Mini Jack
Connect to an emitter.
2
USB
Type B
Port
Connect to a USB host, for example, a PC.
3
HDMI™ IN Connector
Connects to an HDMI source.
4
IR RX on a 3.5mm Mini Jack
Connect to a receiver.
5
Reset Button (under wall plate)
Press briefly to perform a software reset.
Press and hold for 10 seconds to perform a factory reset.
6
LINK LED
On when a
WP-EN6
to
KDS-DEC6
link is established and is transmitting A/V signals.
7
ON LED
Flashes during power up and lights when on.
8
STATUS LED
Identifies a device in a system. When sending a P3K FIND-ME command to the
system, the LED of the device to be identified flashes for 5 seconds.
9
CHANNEL Display
Displays the selected channel. If the channel number exceeds 99, the 100 indicator
turns on (for example, channel 124 appears as “
24”).
10
Ring Tongue Terminal Grounding
Screw
Connect to grounding wire (optional).
11
RS-232 3-pin Terminal Block
Connector (Tx, Rx and common G)
Connect to an RS-232 controller device (to control a device on the decoder side)
12
Power Supply 2-pin Terminal Block
Connector
Connect to a power supply (if required). Connect GND to GND, +12V to +12V.
13
LAN/POE RJ-45 Connector
Connect to the network using recommended Kramer cables. Note that this port
supports power over Ethernet (PoE).
