Kramer Electronics Ltd.
WP-20CT
– Connecting WP-20CT
8
Connecting WP-20CT
Always switch off the power to each device before connecting it to your
WP-20CT
.
Figure 2: Connecting to the WP-20CT Rear Panel
To connect
WP-20CT
as illustrated in the example in
1. Connect the HDMI source (for example, a Blu-ray player) to the HDMI IN connector
.
2. Connect the USB-C source (for example, a tablet) to the USB-C IN connector
.
3. Connect a controller (for example,
RC-306
control keypad) to the Control RS-232
connector
to control
WP-20CT
and to the EXTD RS-232 connector
to control a
device on the receiver side via serial communication.
4. Connect the HDBaseT OUT connector
to the HDBaseT input of a PoE-provider
receiver (for example,
TP-789R
) or a non-PoE receiver (for example,
TP-580R
).
5. Connect an RS-232-controlled device (for example, a projector) to the receiver HDMI
input and RS-232 connector.
6. Connect the included 12V power supply to the 12V/20V connector
for powering the
unit when connected to a non-PoE receiver.
-OR-
Connect an optional PS-2006-O 20V/6A Kramer power supply to the
12V/20V connector
to enable the USB-C charging feature.
1
4
7
8
6
6
6
