![background image](http://html1.mh-extra.com/html/kramer/vs-88uhd/vs-88uhd_user-manual_2001458010.webp)
Kramer Electronics Ltd.
VS-88UHD – Connecting the VS-88UHD
8
Connecting to VS-88UHD via RS-232
You can connect to the
VS-88UHD
via an RS-232 connection using, for example, a PC.
To connect to the
VS-88UHD
via RS-232:
Connect the RS-232 rear panel port on the
VS-88UHD
unit via a
9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5 need to be
connected) to the RS-232 9-pin D-sub port on your PC.
Connecting VS-88UHD via the ETHERNET Port
You can connect to the
VS-88UHD
via Ethernet using either of the following methods:
Directly to the PC using a crossover cable (see
Connecting the Ethernet Port Directly to a
on page
).
Via a network hub, switch, or router, using a straight-through cable (see
Ethernet Port via a Network Hub or Switch
).
If you want to connect via a router and your IT system is based on IPv6, speak to your IT
department for specific installation instructions
Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the
VS-88UHD
directly to the Ethernet port on your PC
using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the
VS-88UHD
with the factory configured default IP address.
After connecting the
VS-88UHD
to the Ethernet port, configure your PC as follows:
1. Click
Start
>
Control Panel
>
Network and Sharing Center
.
2. Click
Change Adapter Settings
.
3. Highlight the network adapter you want to use to connect to the device and click
Change
settings of this connection
.
The Local Area Connection Properties window for the selected network adapter appears
Проконсультироваться
и
купить
данное
оборудование
вы
можете
в
компании
«
АНД
-
Системс
»
адрес
: 125480,
г
.
Москва
,
ул
.
Туристская
,
д
.33/1; site: https://andpro.ru
тел
: +7 (495) 545-4870 email: [email protected]
При
обращении
используйте
промокод
AND-PDF
и
получите
скидку
.