#
Feature
Function
15
ETHERNET
RJ-45
Connector
Connect to a PC or other Ethernet controller via a LAN
16
RESET
Button
Press and hold to reset the Ethernet configuration to its factory default values
17
OUTPUT
DVI Connectors
Connect to the DVI acceptors (from 1 to 8)
18
REMOTE IR
3.5mm Mini
Jack
Connect to an external IR receiver unit for controlling the machine via an IR remote controller
(instead of using the front panel IR receiver)
19
Mains Power Connector
with Switch and Fuse
Connect to the AC mains supply and use the switch to turn the device on or off
Step 3: Mount VS-88HDCPXL
To rack mount the machine, attach both rack ears
(by removing the screws from each side of the
machine and replacing those screws through the
rack ears) or place the machine on a table.
•
Ensure that the environment (e.g., maximum ambient temperature &
air flow) is compatible for the device.
•
Avoid uneven mechanical loading.
•
Appropriate consideration of equipment nameplate ratings should be
used for avoiding overloading of the circuits.
•
Reliable earthing of rack-mounted equipment should be maintained.
Step 4: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your
VS-88HDCPXL
.
To achieve specified extension distances, use the recommended Kramer cables available at
www.kramerav.com/product/VS-88HDCPXL
Using third-party cables may cause damage!
Step 5: Connect power
Connect the power cord to
VS-88HDCPXL
and plug it into the mains electricity.
Safety Instructions (See
for updated safety information)
Caution:
•
For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the terminal or in the User Manual.
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
•
Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
•
To ensure continuous risk protection, replace fuses only according to the rating specified on the product label which located on the bottom of the unit.
Step 6: Operate VS-88HDCPXL
Acquire the EDID from a connected output
1. Press and hold the EDID and STO buttons for 3 seconds. Both buttons
flash.
2. Press the INPUT button that receives the EDID. The input number flashes
on display.
3. Press the OUTPUT button where the display is connected.
4. Press the EDID button.
5. When the buttons stop flashing and the display returns to normal, the
EDID is acquired.
Store a preset
1. Set the device to the desired I/O setting.
2. Press the STO button. The STO button flashes.
3. Select an IN or OUT button to store the device setting.
4. Press the STO button to store the current setup.
Switch an input to an output
Press an output button followed by an input
button to switch the pair.
Recall a preset
1. Press the RCL button. The RCL button
flashes.
2. Press the relevant IN or OUT button.
3. Press the RCL button to recall the stored
setting.
