VS-88HDCPXL
Quick Start
P/N: 2 9 0 0 - 3 0 1 2 5 7 QS
Rev: 5
Scan for full manual
VS-88HDCPXL Quick Start Guide
This guide helps you install and use your
VS-88HDCPXL
for the first time.
www.kramerav.com/downloads/VS-88HDCPXL
to download the latest user manual and check if
firmware upgrades are available.
Step 1: Check
what’s in the box
VS-88HDCPXL
8x8 DVI Matrix Switcher
1 Set of rack ears
4 Rubber feet
Kramer RC-IR3 Infrared Remote Control
Transmitter with batteries and user manual
1 Power cord
1 Quick start guide
Step 2: Get to know your VS-88HDCPXL
Front Panel
#
Feature
Function
1
IR
Receiver and LED
IR remote control sensor. LED lights yellow when receiving an IR signal
2
POWER
LED
Lights green when the unit is turned on
3
ALL
Button
Press to select all inputs or all outputs
4
OFF
Button
Press to disconnect one or all outputs
5
SELECT OUT
Buttons
Press to select an output (from 1 to 8)
Note that when a sink is connected to an output, that output button lights
If a screen that does not support HDCP is connected to an output, the button of that output
may possibly remain unlit
6
SELECT
IN
Buttons
Press to select an input (from 1 to 8)
Note that when there is a live signal at an input, that input button lights
7
STO
Button
Press to store a switching configuration
8
RCL
Button
Press to recall a switching configuration
9
LOCK
Button
Press and hold to lock the front panel buttons and to acquire the EDID.
Press and hold a second time to unlock the front panel buttons
10
EDID
Button
Press to acquire the EDID
11
OUTPUT
1 to 6
Indicates the output channels and their respective input selections on the 7-segment display
12
INPUT
7-segment Display Number shown on the display indicates the relevant input channel
Rear Panel
#
Feature
Function
13
INPUT
DVI Connectors
Connect to the DVI sources (from 1 to 8)
14
RS-232
9-pin D-sub (F)
Connector
Connect to a PC or the serial remote controller
