Kramer VS-6464DN-EM, User Manual, Page: 49 / 94

Kramer Electronics Ltd.
VS-6464DN-EM
– Troubleshooting Video and Audio Problems
47
3. Set the generated video resolution (see Setting the Resolution of the Generated Video
on page 44 ).
4. Set the pattern for the generated video (see Setting the Pattern of the Generated Video
on page 45 ).
5. Verify that the projector output is as expected.
Testing the Input and Output Signal Path to the Projector
Signal path: c to e; e to f; f to b; b to projector.
To test the input and output signal path to the projector:
1. Configure Input 65 to Output 65 (see Switching Actions on page 19 ).
2. Connect Output 65 to Input 1.
3. Configure Input 1 to Output 1.
4. Connect Output 1 to the projector.
5. Set the generated video resolution (see Setting the Resolution of the Generated Video
on page 44 ).
6. Set the pattern for the generated video (see Section 10.3).
7. Verify that the projector output is as expected.
Troubleshooting Audio Problems
The test module may be used in various ways to isolate analog audio problems.
The following examples are based on the audio signal paths shown in Figure 16 and a
VS-6464DN-EM device installed as follows:
•
64 inputs and 64 outputs.
•
The test module is configured (see Installing the Test Module on page 45 ).
•
65 configured inputs and 65 configured outputs (see Configuring the Number of Installed
Input and Output Ports on page 32 ).