Kramer Electronics Ltd.
VS-6464DN-EM
– Troubleshooting Video and Audio Problems
45
shows the Resolution DIP-switch with both switches off (up, default, 480p).
Figure 14: Resolution DIP-switch
Setting the Pattern of the Generated Video
The Pattern button is used to set the pattern of generated video. There are 32 available
patterns. Press the button repeatedly to cycle through the patterns.
Installing the Test Module
By default, the controller and test card is installed in the configuration. If you uninstalled the
test module in the configuration, it must be reinstalled before it can be used, that is, the
number of configured inputs and outputs must be increased by one. For example:
•
If your
VS-6464DN-EM
has eight inputs and eight outputs, you must configure the
VS-6464DN-EM
as 9 x 9
•
If your
VS-6464DN-EM
has 64 inputs and 64 outputs, you must configure the
VS-6464DN-EM
as 65 x 65
To install the test module in the configuration:
1. Press ESC, ENT and LOCK together.
The following is displayed:
Configuration Device
2. Press ENT.
The following is displayed:
Test Board: 0 MaxInput:64 MaxOutput:64
where 0 indicates that the test module is not installed.
3. Using the numeric keys, press 1 to indicate that the test module is installed.
The TAKE button flashes.
4. Press TAKE.
5. Increase the number of configured inputs and outputs by one (see
Number of Installed Input and Output Ports
).
6. Power cycle the device.
The test module is now installed and may be used.
