Kramer VS-62HA, User Manual

Page: 17 / 95

12 VS-62HA - Connecting the VS-62HA
3. Connect the two HDMI OUT connectors to up to two HDMI acceptors, (for
example, LCD displays).
4. Connect the two balanced AUDIO OUT 5-pin terminal block connectors
to up to two analog audio acceptors, (for example, audio receivers).
5. If required, connect a PC/controller to the RS-232 port (see Section
‎5.1
)
and/or the Ethernet port (see Section
‎5.2
).
6. If required for remote switching, connect up to 6 contact closure switches
per channel to their terminal block connectors (Remote 1 and 2
Switches).
7. If required for remote switch indication, connect up to 6 LEDS per
channel to their terminal block connectors (Remote 1 and 2 LEDS).
8. Connect a power cord to the device and plug it into the mains electricity
(not shown in Figure 3 ).
9. If required, acquire the EDID (see Section
‎7.1
).
5.1 Connecting a Serial Controller to the VS-62HA via
RS-232
To connect a serial controller to the VS-62HA:

From the RS-232 9-pin D-sub serial port on the serial controller connect:

Pin 2 to the TX pin on the VS-62HA RS-232 terminal block

Pin 3 to the RX pin on the VS-62HA RS-232 terminal block

Pin 5 to the GND pin on the VS-62HA RS-232 terminal block