VS-3232DN - Using the Input / Output Cards
49
10 Using the Input / Output Cards
This section defines the input / output cards and their relevant parameters.
Not all options are displayed for every menu selection. Some
parameters depend on the specific selection of other parameters.
The volume control provides only attenuation, not gain. Hence,
setting volume to 100% provides 0 attenuation.
10.1 Defining the HDBT-IN4-F32 / HDBT-OUT4-F32
The
HDBT-IN4-F32
is a 4-Input HDMI over HDBaseT Card (F-32):
The
HDBT-OUT4-F32
is a 4-Output HDMI over HDBaseT Card (F-32):
HDBT Input Cards
: The chassis is limited to a maximum of three HDBT input
cards due to thermal constraints. When installing these input cards they must
occupy input slots IN 5~8, IN 9~12, and IN 13~16 (in that order, as needed). Input
slot IN 1~4 must be left unpopulated and sealed with a blank cover. Contact
Kramer Electronics for more information on installing a fourth HDBT input card.
The HDBT input card limitations are only relevant for the
VS-3232DN
. This limitation is not applicable to the
VS-3232DT
which
may be fully populated with HDBT input and output cards.
HDBT Output Cards
: There is no limitation on the number or type of output cards
that can be installed.
The
HDBT-IN4-F32
and
HDBT-OUT4-F32
cards include a terminal block for
connecting via RS-232 or an IR emitter, such as the
C-A35M/IRE
, or an IR
receiver, such as the
C-A35M/IRRN
. For information on the IR wiring scheme, see
Section 10.1.3
. For information on connecting via RS-232, see
Section 5.2
